Komatsu — 20.6.4 SUPPLEMENTAL COOLANT ADDITIVES

MAINTENANCE WARNING Use extreme caution when adding coolant to a hot radiator to avoid being burned. Wear gloves and goggles and keep face away from the filler neck. Check the solution periodically and at normal operating temperature, to be sure the cooling system has sufficient protection against freezing. An antifreeze concentration greater than 68% will adversely affect antifreeze protection and heat transfer rates. Antifreeze concentrations between 68% and 100% actually have a higher freezing point than a 68% antifreeze concentration and should not be used due to reduced heat transfer rates.

REMARK Do not use a 100% antifreeze solution for freezing protection, This will cause severe corrosion in the cooling system and if not detected will cause radiator and oil cooler core damage. Use a water/antifreeze solution as described in the following table. The following table shows the approximate percentage of antifreeze solution required for various temperatures. In tropical climates where antifreeze availability may be limited, use a corrosion inhibitor or supplemental coolant additive (SCA), to protect the engine cooling system. 20.6.4 SUPPLEMENTAL COOLANT ADDITIVES 1.

All supplemental cooling system additives, including those in antifreeze solutions, become depleted through normal operation. If the coolant additives in antifreeze are allowed to become depleted, the antifreeze becomes corrosive and attacks and coats the metallic surfaces of the cooling system which reduces heat transfer. Cooling system conditioners which contain these additives must be added to maintain corrosion protection. 2. Soluble oil is not recommended for use in this engine as its use will reduce heat transfer and allow internal engine damage. There are no miracle additives that will increase heat transfer or prevent overheating. Conditioned water is still the best coolant.

A corrosion inhibitor/conditioner is recommended to inhibit corrosion in the cooling system for the following reasons: Improved compatibility with high silicate antifreezes to minimize hydro-gel formation if over concentration occurs. Provides engine protection in the following areas:

- Solder corrosion/bloom - Cylinder liner cavitation corrosion - Copper corrosion/erosion/stress cracking - Aluminum cavitation corrosion - Oil fouling - Seal and gasket degradation WA380-3MC 3-13 Approximate Freezing Point Percentage of Antifreeze Concentration by Volume Specific Gravity at 16 0 (+32 -7 (+20 -12 -18 -23 (-10 -29 (-20 -34 (-30 -40 (-40 -46 (-50 -51 (-60 -57 (-70 -62 (-80 -68 (-90 -69 (-92 0 15 25 33 40 45 48 53 56 59 62 65 67 68 1.000 1.025 1.040 1.053 1.062 1.070 1.074 1.080 1.083 1.088 1.092 1.095 1.097 1.098