OPERATION 12.2.1 COLD WEATHER STARTING WARNING Use the ether start switch only when starting the engine. Keep the sparks and flames away from the ether cylinder. Never throw a cylinder into a fire. Never drill a hole in the ether cylinder. Do not store an ether cylinder where the temperature will rise to 40 contact with the ether gas. Keep the ether cylinder out of the reach of children. NEVER use ether when using an air intake preheating device. NOTE: An ether cylinder holds 710 cc, which is enough ether for about 230 uses (3 cc is injected for each shot).
Remove the ether cylinder in warm weather and store the cylinder in a safe place where the temperature is below 40 When the ambient temperature is below 25 ether cylinder in place at room temperature. Before changing the ether cylinder, clean out the valve area where the cylinder is installed and replace the gasket at the same time. 1. Turn the key in the start switch to the ON position. 2. DO NOT depress the accelerator pedal. 3. Turn the key to the START position to start the engine. 4. Move the ether start switch to the ON position, but for no more than five seconds. Holding this switch for longer than five seconds will cause the ether start valve to fail. NOTE:
If the engine does not start on the first attempt, wait two minutes before repeating this cycle. You may need to repeat this cycle 2-3 times. WA380-3MC 2-49