Deutz — ALL ROUND TESTER MANUAL - MK3 80-105 SERIES

ALL ROUND TESTER MANUAL ALL ROUND TESTER MANUAL - MK3 80-105 SERIES ELECTRONIC COMPONENTS CONTROL AND SETTING SYSTEM STRUCTURE OF THE SYSTEM Settings are made for electronic components using the same device as used for collecting diagnostics information, the "ALL ROUND TESTER ®", which is also referred to on the following pages as ART®. This device can be used to: Display alarm codes Carry out calibration and setting operations Display vehicle operating data picked up and relayed back through the various control units (e.g. sensor readings) pi- loting the different electronically controlled systems.

The exchange of data between the control units and the ART® is enabled by connecting the ART® to the diagnostics and communication socket on the right hand console. To help you carry out the programming for the specific tractor, set the parameters that can be programmed using the ART® and list the alarms detected by the control units. The following section contains all the screen pages relative to the in- dividual control units along with explanations of the messages displayed on the ART®. The functions of the ART® can also be performed using a Personal Computer, having installed the relative software “PCTESTER” (code 0.011.7437.4). 20-123