ALL ROUND TESTER 4. ALARMS LIST OF DIAGNOSTIC ALARMS 20-137 Standard CODE Extended CODE MESSAGE on PC Tester or ART DESCRIPTION 88 11 Alarm not recorded Checksum EPROM program not valid 26 12 “Posit.Sens.Power” Position sensor power supply incorrect 13 13 “ShortCirc.PWM“ Short-circuit of PWM outputs 53 14 “ShortCirc.ASM“ Short-circuit of ASM outputs 18 16 “LiftCntrlLever.” Lift control lever 22 18 “Pos.Sens.Disc” Position sensor not connected 11 21 “ShortCirc.EVUP” Short-circuit of SvUp 11 23 “SvUpDisc. L” SvUp not connected (static test - Sv off) 11 24 “SvUpDisc. D” SvUp not connected (dynamic test - Sv on) 12 31 “ShortCirc.SvDw ” High short-circuit of SvDw 12 33 “SvDwDisc.
L” SvDw not connected (static test - Sv off) 12 34 “SvDwDisc. D” SvDw not connected (dynamic test - Sv on) 51 41 “ShortCirc. 4WD” Short-circuit of 4WD output 51 43 “4WD Disc. ” 4WD output not connected (static test - Sv off) 52 51 “ShortCirc.DIF” Short-circuit of SvDIFF 52 53 “SvDIFDisc.
” DIFF solenoid valve not connected (static test - Sv off) 31 62 “RHDraftDisc.” Right-hand draft sensor not connected 32 63 “LHDraftDisc.” Left-hand draft sensor not connected 42 64 “Wheel sens.disc.” Wheel sensor not connected or faulty 41 65 “Radar Disconnected” Radar not connected or faulty 26 67 “5V power “ 5V sensor power incorrect 16 68 “8V power “ 8V sensor power incorrect 34 71 “Low.SpeedPot.Disc.” Lowering speed potentiometer short-circuited or disconnected 23 72 “Control Pot. “ Control potentiometer short-circuited or disconnected 36 73 “Mix Pot. “ Mix potentiometer short-circuited or disconnected 24 74 “Max.HeightPot.
” Maximum Height potentiometer short-circuited or disconnected 54 76 “EEPROM :OPTION “ EEPROM checksum not correct - Options menu 54 77 “EEPROM : SPEED “ EEPROM checksum not correct - Parameters menu 54 78 “EEPROM : CALIB “ EEPROM checksum not correct - Calibrations menu 55 81 “EEPROM : CTRL “ EEPROM checksum not correct - Control menu 55 82 “EEPROM : PWM “ EEPROM checksum not correct - PWM menu 55 83 “EEPROM : DRAFT “ EEPROM checksum not correct - Draft menu 55 84 “EEPROM : SLIP “ EEPROM checksum not correct - Slip menu 55 85 “EEPROM : POS “ EEPROM checksum not correct - Position menu 55 86 “EEPROM : AB “ EEPROM checksum not correct - Antidumping menu 55 87 “EEPROM :
SFCFG “ EEPROM checksum not correct - Draft config. menu 55 88 “EEPROM : SLCFG “ EEPROM checksum not correct - Slip Config. menu 88 -- Non coded alarm All non coded alarms (probable software problem)