Deutz — REFITTING

AIR BRAKING SYSTEM VALVES REFITTING THE AIR BRAKING SYSTEM VALVES Refitting is the reverse of removal. 1 - Start the engine and allow the pressure to build in the air braking circuit. 2 - Check the seal at all removed fittings using a soapy solution. 3 - Bleed the brake circuit of air. (For details, see «BLEEDING THE BRAKE SYSTEM»). 4 - Check that the parking brake valve control lever op- erates at the correct point and, if necessary, adjust the length of the tie-rod. Adjusting the length of the tie-rod 1 1 - Check that the parking brakes are perfectly adjusted and that they are released.

2 - Raise the parking brake lever to the first notch; you should distinctly hear the parking brake valve operate in correspondence with the first notch position. 3 - If the valve operation is too ADVANCED, lengthen the control rod. If the valve operation is too RETARDED, shorten the control rod. 4 - Operate the parking brake a few times, checking that the tractor and trailer brakes are applied simultane- ously. 30-30