CONDENSER ASSEMBLY REMOVAL OF THE CONDENSER ASSEMBLY (The figures depict models with 6-cylinder engines) Remove the key from the ignition and engage the parking brakes. 5 1 - Remove the side panels. 2 - Recover the refrigerant from the system. (For details see «DISCHARGING, FLUSHING AND RECHARGING THE AIR CONDITIONING SYSTEM»). 3 4 3 - Disconnect the pipes (2) and (3) from the condenser (1). Immediately plug the open ends of the pipes to prevent moisture from getting into the system. 1 1 4 - Unscrew the knobs (4) and remove the cowling (5). 2 F0044170 5 - Tilt the mounting brackets (6) forwards. 6 - Remove the lower pivot bolts (7).
On models with 4-cylinder engines, remove the four bolts (8). 8 6 7 8 F0044180 7 - Remove the condenser assembly (1). Take care not to damage the fins. 1 REFITTING THE CONDENSER ASSEMBLY F0044190 Refitting is the reverse of removal. 1 Remove the plugs and connect the pipes imme- diately, fully tightening the fittings, to prevent moisture getting into the system. Check the condition of the O-ring seals and renew them if damaged. 1 - Flush and recharge the system. (For details see «DISCHARGING, FLUSHING AND RECHARGING THE AIR CONDITIONING SYSTEM»). 30-42