BLEEDING THE BRAKING SYSTEM BLEEDING THE BRAKING SYSTEM 1 - Disconnect the two brake pedals (1) by disengaging the latch pin (2). 2 - Bleed the left rear brake. 1 3 - Bleed the right rear brake. 4 - For tractors with hydraulic or air trailer braking only: bleed the trailer brake valve before bleeding the service brake system. 2 F0018791 Brake bleeding procedure During brake bleeding operations, ensure that the flu- id in the brake fluid reservoir is always above the min- imum level. 1 - Remove the dust cap and attach a transparent bleed tube “ A ” to the bleed screw (1) of the cylinder (2). 1 A 2 - Fully depress the brake pedal corresponding to the brake to be bled.
2 3 - Slowly open the bleed screw (1) and allow the fluid and air to flow throughout the entire pedal travel. F0044740 4 - While holding the pedal fully depressed, tighten the bleed screw. 5 - Repeat the operation until the fluid flowing from the bleed screw is entirely free of air bubbles. 6 - Repeat the procedure for the remaining brake cylin- der. 7 - After bleeding, replace the bleed screw (1) dust caps. 8 - Use the same method also for the service brakes. Bleed the left brake first and then the right brake. F0044750 1 30-70