POWER STEERING UNIT ASSEMBLY OF THE POWER STEERING UNIT Before assembly, lubricate all components with gear- box oil. 1 - Insert the two flat springs (23a) and position them cen- trally relative to the diameter of inner sleeve of the spool (17a). Insert the four curved springs (23b), ar- ranged in pairs, between the two flat springs (23a) and push them in fully. 23 a 23 b 23 a 23 b 17 a F000 9690 2 - Align the springs (23). 23 F000 9700 3 - Insert the inner sleeve (17a) in outer sleeve (17b). Check that the relative positions of the inner and outer sleeve are as described in stage 1.
17 b 17 a F000 9580 4 - Simultaneously push the springs (23) and the inner sleeve (17a) so that the springs locate in the outer sleeve (17b). 23 17 a 17 b F000 9710 30-82