Deutz — REFITTING

FRONT WHEELS REMOVAL OF THE FRONT WHEELS On tractors with front suspension, before stopping the engine to remove the front wheels, disengage the front axle suspension by pressing the relative button in the cab. 1 - Apply the parking brake. For normal front axles 2 - Position under the differential housing a trolley jack A ” with a minimum lifting capacity of 5 tons and a maximum lift height of at least 15 cm (6 in.). Drive safety wedges between the axle and the axle support. For suspended front axles 2 - Position centrally under the pivoting support (1) a trol- ley jack “ A ” with a minimum lifting capacity of 5 tons and maximum lift height of at least 15 cm (6 in.).

3 - Raise the front end of the tractor sufficiently to elim- inate flexure of the tyre walls and to lift the wheels by approximately 2 cm (0.8 in.). B B 1 4 - Position two jacks “ B ” under the axle; lower the trolley jack so that the axle is supported on the jacks “B” with the wheels off the ground and then remove trolley jack A Jack lifting capacity: minimum 2 tons. A F0044820 5 - Slacken off all the wheel nuts (2); remove the wheel nuts, leaving one (for safety) at the top of the wheel. 1 6 - While holding the wheel vertical, remove the last nut and remove the wheel (3). 7 - Repeat the above operations to remove the other rear wheel.

2 3 F0044830 REFITTING THE FRONT WHEELS Refitting is the reverse of removal. 1 4WD wheel nuts: 350 Nm (258 lb.ft.) Tighten the wheel nuts gradually in a crosswise se- quence. 30-92