REAR WHEELS REMOVAL OF THE REAR WHEELS 1 - Position under the rear gearbox a trolley jack “ A ” with minimum lifting capacity of 5 tons and a maximum lift- ing height of at least 15 cm (6 in.). Position the trolley jack “ A ” so that it is nearer to the wheel to be removed. 2 - Raise the tractor sufficiently to eliminate the flexure of the tyre wall. A F0044860 3 - Slacken off all the wheel nuts (1); leaving one (for safe- ty) at the top of the wheel. 1 2 1 4 - While holding the wheel vertical, remove the last wheel nut and remove the wheel (2).
F0044051 5 - Position under the rear axle an axle stand “ B ” with lat- eral retaining wings for safety and lower the trolley jack until the axle is resting on the axle stand. Axle stand load capacity: 2 tons minimum. 6 - Check that the stand is in exactly the right position and then remove the trolley jack. 7 - Repeat the above operations to remove the other wheel. F0044870 B REFITTING THE REAR WHEELS Refitting is the reverse of removal. 1 Wheel nuts: M18x1.5: 350 Nm ± 10%(258 lb.ft. ± 10%) Tighten the wheel nuts gradually in a crosswise se- quence. 30-94