Deutz — REMOVAL

FRONT LIFT ASSEMBLY REMOVAL OF THE FRONT LIFT ASSEMBLY Raise the lift arms to the maximum height and stop the engine. 1 - Disconnect the lower pipes from the valve block (1). Loosen the fitting by a few turns, but before fully disconnecting them, push them to detach them from the couplers and release any residual pres- sure in the system. Label the pipes to avoid confusion on reconnec- tion. Plug the ends of the pipes and the open fittings on the valve block to prevent the entry of contami- nants. 1 F0018020 2 - Remove the lift arms (2) and the pivot pins (3) complete with their retaining chains. 3 - Remove the shaft end cover (4) and the shield (5).

2 2 4 5 3 3 F0018030 4 - Position under the lift assembly (6) a jack” A ” that can be lowered by at least 10 cm. (4 in.). 6 A F0017971 5 - Remove the bolts (7) and remove the upper pivot pins (8) of the cylinders (9). 8 9 9 7 F0017981 30-98