Deutz — REFITTING

SUPPLY VALVE FOR THE FRONT SUSPENSION CONTROL VALVE REMOVAL OF THE SUPPLY VALVE FOR THE FRONT SUSPENSION CONTROL VALVE Fully lower the front suspension and discharge the hy- draulic pressure. 1 - Stop the engine, remove the key from the ignition and apply the parking brake. 3 1 2 - Allow the engine to cool down to ambient tem- perature. 1 - Unplug the connector (3) from the solenoid (1) of the valve (2). 2 F0045250 2 - Unscrew and disconnect the following from the valve (2): the drain port fitting (4), the delivery pipes to the control valve (5), the pipe (6) from the pump and the front axle suspension supply pipe (7). 2 3 - Remove the valve (2). 4 7 5 6 F0045260 4 - Only if necessary:

remove the solenoid (1) and the spindle (8). Carefully check the condition of the O-rings (9) and the backup rings (10). 1 1 8 F0045270 REFITTING 9 Refitting is the reverse of removal. 1 If new O-rings (8) and backup rings (9) are fitted, check they are positioned correctly. 9 10 1 - Start the engine and raise and lower the front axle sus- pension a few times to expel all the air from the sys- tem. F0045280 30-125