Deutz — HOW TO CONSULT THE UNIT

HOW TO CONSULT THE UNIT How to consult the table The quickest way to determine the cause of a malfunc- tion of a component (e.g. the starter motor) is to check all the components in the system in which the component is incorporated. In this example, the problem is a malfunction of the start- er motor, which fails to start the engine. 1 - Look in paragraph “ 2.1. Component description index ” for the starter motor and identify the system in which it is incorporated. The system is indicated in the column “ System (para 4.xx) ” and in this case is “ 2 ” (figure A).

2 - Consult paragraph “ 4.2 Starting ” (figure B), in which the electrical diagram indicates all the com- ponents in the system; these components are ac- companied by numbers that correspond to the key on the same page. 3 - Check all the components in the system, starting, for example, with the switch “ 2 4 - Look in paragraph “ 2.1. Component description index ” (figure A) for “ Starting enabling switch (Green) ” and check in the column “ Technical (para 3.2.xx) ” if there is a technical description of the component (in this case it is given at n° 11 of the paragraph “ 3.2 Component technical data ”) (fig- ure C).

Note down also the name of the connector to which the component is connected (in this case START Only if the position of the component is not known 5 - Look in paragraph “ 2.3 Connector index ” (figure D) for the name of the connector to which the com- ponent is connected (in this case “ START ”) and note down the wiring harness in which it is incor- porated (in this case “ 0443.7847 ” or “0.012.3639.4”) and the type of connector (in this case “ 10 6 - Look for the wiring harness in chapter “ 5. Layouts, electrical wiring diagrams, connector posi- tions ” using the index at the beginning of the chap- ter.

7 - Look for the name of the connector in the photos at- tached to the electrical diagrams and determine its position on the tractor from the drawing (figure E) . NOTE . In the electrical diagrams (figure F) are indicated the names of the connectors and the descrip- tions that are used in all the tables of chapter 2. 8 - Using the data contained in the paragraph “ 3.2 Component technical data ” (figure C) in position n° 11 , check the operation of the switch.

If the pinout of the connector is not known, look in paragraph “ 3.1 Connector layouts ” (figure G) for the number found in the column “ Type ” of para- graph “ 2.3 Connector index 12 0443.7847/20 0443.7847/20 START 0443.7847/20 40-2 START E B A 0443.7847 START 2 Starter enable switch (green) F 2 2 START Start enable switch (green) HOW TO CONSULT THE UNIT 2 Starter motor 2 START START 0441.6066 START X47 11 0443.7847 Start enable switch (green) 10 10 START C D G 10 11