Deutz — 1.11 END COMMUNICATION

SERDIA ENTRY AND COMUNICATION 1) As a printout. A suitable printer driver has to be selected under Windows. At the top of all printouts, the logistical data appear: Type of ECU Date and time Interface serial number Engine number Part number functional data set Number of operating hours 2) The ECU data can also be stored as a file. This file can be further processed in Excel. The following table gives an overview of the possibilities for storing data from the various screens: as printable files for further processing, e.g. in Excel as configuration files to report changes as a graphic file (*.egr) readable in the SERDIA demo mode.

1.10 PROTOCOL (PROTOKOLL) This switch is only provided within the scope of development for configuration of the interface. 1.11 END COMMUNICATION 1.11.1 PROGRAM END Before you disconnect the notebook from the engine ECU, you should return to the main menu and click on "Close". If you have modified any parameters, in many cases it is worth checking the current parametrization, for safety's sake. Proceed by carrying out the following steps: 1. End SERDIA 2. Switch off engine power supply, and then switch on again 3. Start SERDIA again 4. Re-activate the ECU 5. Activate the menu point “Parameters” 6. Click on -> PC” (“SG -> PC”) in the configuration screen. 7.

To print out the configuration data, press "Print" (“Print ON”). 8. File the printout with the engine documentation 1.11.2 DISCONNECTING THE ECU You should only disconnect the engine ECU from the notebook (i.e. interface with cable) after you have left the program SERDIA by pressing "Close". 20-12 From screen Button Extension Notes Service Diagnosis Print (File) *. Ecu for further processing, e.g. in Excel Actual measured values File *. Msw for further processing, e.g. in Excel Graphics ( ASCII ) *. Agr for further processing, e.g. in Excel Graphics ( binario ) *. Egr readable in the SERDIA demo mode Input/output assignment Print (File) *. Ino for further processing, e.g.

in Excel Configuration Print (File) *. Kfg for further processing, e.g. in Excel Configuration Save in file *. Hex Configuration file (partial data set, level-dependent) Overall programming ECU -> File *. Hex Configuration file (complete data set, Level III and Ilia) Error memory Print (File) *. Err for further processing, e.g. in Excel Logistical data Print (File) *. Dat for further processing, e.g. in Excel