Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE WARNING 3. Following this, push radiator cap (1), turn it until it contacts the stopper, then remove it. 4 - 27 Antifreeze is flammable, so keep it away from flame. Antifreeze is toxic. When opening t flush your eyes with large amount he drain valve, be careful not to get water containing antifreeze on you. If it gets in your eyes, of fresh water and see a doctor at once. When changing the coolant or drai ning the coolant from the radiator before carrying out repairs, a sk a specialist company to handle any coolant containing an drainage water ditches or drain it o tifreeze, or contact your Komatsu distributor.

Antifreeze is toxic, so never pour it into nto the ground surface. se antifreeze and appropriatewa ter for diluting. (for details, see "COOLANT AND WATER FOR DILUTION (PAGE -5)") se f river water, well water or other s uch water supply must be used , contact your Komatsu d We recommend use of an antifre eze density gauge to control the mixing proportions. repare a container whose capac ity is larger than the specified coolant volume to catch d repare a hose to supply antifree 1. Stop the machine on level gr ound, then stop the engine. 2. Check that the coolant tempe rature has gone down enough to make it possible to touch the then turn radiator cap (1) slow release the pressure.

radiator cap surface by hand, ly until it contacts the stopper to 4. Remove the undercover, the n set the container under drain mixture. valve (2) to catch the coolant Open drain valve (2) at the bo ttom of the radiator and drain the coolant. 5. After draining the coolant, clos e drain valve (2), and fill with city water. When the radiator is ful l, start the engine and run at low idling to raise the temperatur e to at least 90°C (194°F), then minutes. alve (2), and drain the water. the radiator with detergent. w the instruction of detergent. eeze until it overflows from the continue to run for approx. 10 6. Stop the engine, open drain v 7.

After draining the water, clean For the cleaning method, follo 8. Close drain valve (2). Install the undercover. Add coolant mixed with antifr water filler. 9. 0. Decide the proportions of antif reeze and water according to the table for the mixing rate of wa ter and antifreeze. for 5 minutes to remove the air gh idling for 5 minutes. (Leave n doing this.) 1. Run the engine at low idling from the water, then run at hi radiator cap (1) removed whe