. MAINTENANCE MAINTENANCE PROCEDURE Adjustment WARNING 4 - 30 CHECK AND ADJUST TRACK TENSION The wear of the pins and bushings on the und ercarriage will vary with orking conditions and typ e of so il, so inspect the t rack tension fr equently in order to maintain the standard tension Stop the ma chine on firm, horizontal ground w hen carrying out the inspectio n and Checking engine at low idle, move the machine forward a 1. Run the distance machine 2. Choose roller (2) 3. Measure the track Stand Deflec 1. Run the equal to the l ength of track on gr ound, then stop the . 2. Choose wooden block (3) that will reach fro m idler (1) to carrier , then place it on top of the track. 3.
Measure the maximum deflection betwee and the botto m surface of the wo ard deflection tion "a" shoul d be 10 to 30 mm (0 If the track t ension is not a t the standard value , adjust it in the following man There is dange r of plug (1) flyi ng out under the high in ternal pressure of the grease. Neve r loosen plug (1) more than 1 turn. Never loosen any part other mounting dire ction of plug (1) If the track te nsion cannot b please contac t your Komatsu Increasing Track Tension Prepare a grease pump. Prepare a gr 1. Pump in 2. To chec idle, mov of track 3. Check th adjust it 1. Pump in grease throug h grease fitting (2) w ith a grease pump. 2.
To chec k that the track tension is correct, r un the engine at low e the machin e forward a distance equal to the length on ground, the n stop the machine. 3. Check th e track tensio n again, and if the te nsion is not correct, again.