. MAINTENANCE MAINTENANCE PROCEDURE ADJUST BUCKET CLEARANCE WARNING (6) (7) Arm Bucket 4 - 38 It is dangerous if the work equipment is mistakenly moved whe n adjusting the bucket clearance Set the work equipme nt in a stable condition, stop t he engine, th en set lock lever securely to the 1. Set the work eq uipmentin the position sho wn in the di agram on the right, then LOCK position stop the engine and set the lock lever to the (L). ) of the linkage and measure the amount of is easier of you move the bucket to one side the 2. Shift O-ring (1 clearance "a". Measurement (right side of th be measured i Use a gap measurement. side e diagram) or the other so all the clearance can n one place.
(clearance) gauge for easy and accurate mounting bolts (2), and loosen plate (3). split type, so the operation can be carried out 3. Loosen 4 plate mounting bolts (2), and lo osen plate The shim is a without removi 4. Remove shim ( measured abo ng the bolts. 4) correspondingto the amount of clearance "a" ve. [Example] In the case of mm (0.039 in) becomes 0.5 m (0.039 in) and When clearanc any maintenan clearance of 3 mm (0.118 in), remove two 1.0 shims and one 0.5 mm ( 0.020 in) s him. Play m (0.020 in). For shim (4), two types of 1.0 mm 0.5 mm (0.020 in)are used 5. Tighten the fou If the bolts (2) a for easier tight re too stiff to tighten, pull o ut pin stopp er bol t (5) ening. carry out