Komatsu — EVERY 250 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE available 3. After adding distilled water, tighten cap (2) securely. REMARK (sodium or or there is no display of the UPPER the water (UPPER so with of your 4 - 52 2. UPPER LEVEL (U. L.) and LOWER LEVE L (L.L.) lines, r cap (2) and add p urified water (e.g. co replenishment wate r for a battery) to the If distilled water is adde d to above the UPPE use a syringe to lower the level to the UPPE R LEVEL (U.L Neutralize the remo ved fluid with bak h it away with a large ing soda (s amount of w aker.

bicarbonate), then flus consult your Komatsu distributor or battery m When it is Impossible to Check Electrolyte Level from Side of Battery If it is impossible to ch eck the electrolyte lev el from the si as follows. de of the batter batter LEVEL line on the side of the battery, check 1. Remove cap (2) at t he top of the battery, lo ok through the filler port (3), and electrolyte does no (e.g. commercially so that the level re LEVEL line) withou (A) Suitable leve (B) Low: Electrol poles a filler port (3), and electrolyte does no check the electrol t reach the sleeve (4 yte surface. ), add purified (e.g.

commercially available replenishme nt water for a b so that the level re LEVEL line) withou aches the bottom of the sleeve (U t fail. l: Electrolyte level is up so surface tension surface to bulge and to bottom of s causes elec poles appea (B) Low: Electrol yte level is not up to bottom of slee bent. ) securely. ppear straight and not 2. After adding distille d water, tighten cap (2 REMARK If water is added to abo ve the bottom tip of the sleeve, use a to remove electrolyte. sodium bicarbonate, th Neutralize the remo en flush it away with ved electrolyt a large amo water. If necessary, c battery maker.

ontact your Komatsu distributor o When it is Possible to Use Indicator to Check Electrolyte Le If it is possible to use a n indicator to check th e electrolyte l evel, follow the