. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 13. Loosen the knob of feed pump (5), pull it out, then pump it in and out until the movement becomes heavy. at the top of the fuel same procedure to 4 - 70 Replace inner s NOTICE filter cartridge with fuel. Do not fill the new Remove cap (B) a nd install the filter cartridge. 8. When installing , tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartr idge is tightened too far, t he packing will be damaged and this will lea d to leakage of fuel.
If the filter cartridge i s too loose, fuel will also l eak from the packing, so always tighten the correct amount. 9. Turn the valve (1) at the bottom of the fu el tank to the OPEN position (O). r cartridge (2), bleed the air. f the fuel pre-filter is tightened securely. hten the correct amount again. 10. After completin g the replacement of filte 11. Check that dra in valve (3) at the under o When if fuel lea k from the drain hose, tig Bleed the air as fol 12. Fill the fuel tan k with fuel (to the position REMARK It is not necess pre-filter and fue After the engin operate feed pu mp (5) and bleed the air. 14. Push in the kn ob of feed pump (5) and ti 15.
After replacing the filter cartridge, start t he engine and run it at low idling for 10 minut Check for leaka ge of oil from the filter sea l surface. If any oil is leaking, check the tighte ning of the filter cartridge. If there is still oil leakage, repeat Steps 1 - 4 to remove the filter cartridge, and if an y damage or embedded foreign materia l in the packing surface is found, replace it with a new cartridge and rep eat Steps 5 - 13 to instal it.