Komatsu — EVERY 5000 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CHANGE OIL IN HYDRAULIC TANK WARNING and may cause burns. Wait for the 4 - 78 EVERY 5000 HOURS MAIN Carry out the periodic maintenanc e work of every 100, 250, 500 and 1000 hours of operation at the same t The parts and oil are at high tem perature immediately after the engine is stopped, a ting the work. temperature to go down before star Wh en removing the oil filler cap, tu rn it slowly to release the internal pressure, then remo NOTIC E machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket If the raulic breaker, the hydraulic oil wil operations. For details, see "MAIN maintenance.

TENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out Re fill oil amount: 90 liters (23.7 Prepare a handle (for the socke 1. S wing so that the drain plug at the bottom of the hydraulic tank in the middle between the le ft and right tracks. 2. R etract the arm and bucket cyl inders, then lower the boom and ut the teeth in contact with th 3. S et the lock lever to the LOCK 4. R emove cover at the top of the hydraulic tank, then remove the ca p of oil filler (F) over the hyd raulic tank. 5. R emove cover at the under of the hydraulic tank, then set the oi h C re Ti l container under the drain pl ug under the machine. Using the andle, remove drain plug (P) and drain the oil.

plug (P), and if it is dam-aged, heck the O-ring installed to place the O-ring. After draini ng the oil, tighten drain plug (P). m (6-8 kgm, 43.4-57.9 lbft). ghtening torque: 58.8-78.4 N Take care not to get oil on yourself when you remove drain plug (P). 6. A dd the replacement amount of oil through oil filler (F). Check that the oil level is between th e H and L li nes on th F e sight gauge. ee "Check Oil Level in Hydraulic Tank, Add Oil (PAGE 3-113)". or details of oil level check, s ee "Check Oil Level in Hydraulic Tank, Add Oil