Komatsu — ATTACHMENT REMOVAL AND INSTALLATION

. ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT ATTACHMENTS AND OPTIONS MACHINE READY FOR ATTACHMENT right angles to long direction of arm) tank. 6 - 11 6. one down, set the rotor of the stop valv e (installed to the pipin g for the outlet port and inlet port on th sition (b). : Hydraulic oil flows (dire LOCK po (a) FREE long direction of arm) When s etting the FREE or LOC K position of the stop v alve move bolt (2), turn over p late (1), then turn the r otor. tting, install plate (1) aga 7. Remove t he hoses on the attachme nt side. Install the plug s to the two o The plugs operation caused by mixing in of for eign matter. After the p lugs are correc tly installed, store the att 8.

Pull out th e mounting pins (2 place s), remove the attachment, then insta ll the bucket. s of the procedure for installing the bucket, see REPLACEMENT AND INVERSION (PAGE lling the bucket, check the oil level in the hydraulic installing the bucket, see For detail see "BUCKET 3-166)". 9. After insta