Komatsu — 21.2 TORQUE LIST

21. STANDARD TIGHTENING TORQUES FOR BOLTS AND NUTS 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and nuts to the torque shown in the table. The tightening torque is determined by the width across the flats @ of the nut and bolt. If it is necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter):

INm + 0.1 kgm T r Thread diameter of bolt (mm) Width across fiats (mm) (a) (b) kgm Nm 6 8 10 13 1.35 f 0.15 13.2 k 1.4 3.2 k 0.3 31.4 * 2.9 10 12 14 17 19 11.5 * 1.0 112 + 9.8 6.7 k 0.7 65.7 k 6.8 16 24 28.5 + 3 279 * 29 22 18.0 i 2.0 177*19 20 30 56 + 6 549 k 58 18 27 39 k 3 383 k 39 22 32 76 i 8 745 k 78 24 36 94.5 + 10 927k 98 27 41 135f15 1320*140 30 46 175* 20 1720 k 190 33 50 225k 25 2210 i 240 36 55 28Ok 30 2750 + 290 39 60 335+ 35 328Ok 340 When tightening panels or other parts having tightening fixtures made of plastic, be careful not to use excessive tightening torque: doing so will damage the plastic parts. NOTICE 3-l 5