Komatsu — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.8 ADJUST BRAKE PEDAL (TEST, ADJUST STEERING BRAKE) If the travel of the brake pedal increases, the brake lining may be worn out. Adjust brakes as follows. Adjustment Adjust both left and right brakes. 1. Remove the rear cover and order. inspection cover 0 in this 2. Tighten adjustment nuts 0, @I to torque of 4 kgm until the lining contacts the drum. Then, turn adjustment nuts 0, 0 in reverse directions for 2.5 rotations. 3. Check the travel of the brake pedal, refering to “24.3 CHECK BEFORE STARTING”. The standard clearance between the brake lining and the drum should be 0.3 mm.

Basically speaking, this completes the adjustment of the brake band clearance, but to ensure that the clearance be- tween the lining and drum is the same on both the left and right side, check as follows. If there is a difference between the clearance of the left and right brakes, the brakes will pull to one side. Test, adjust left steering brake Open inspection cover 0 under the operator’s seat. Lever 0 can be seen behind the oil level gauge tube. Hook the end of a steel tape measure on the end of lever 0 at a position as close as possible to yoke 8. Read the movement of the steel tape (lever 0) while the brake pedal is depressed fully.

It is easy to read the movement of the lever if you watch edge 0 of the inspection cover. If the movement is 30 mm, it is normal. If the movement is not 30 mm, carry out fine adjustment with left adjustment nut 0 as follows. If it is LESS than 30 mm, LOOSEN nut 0 If it is MORE than 30 mm, TIGHTEN nut 0 3-34