11. EXPLANATION OF COMPONENTS 8. BLADE CONTROL LEVER Lifting and tilting control This lever is used to raise or tilt the blade. @ RAISE( L ) @ HOLD ( K ) Blade is stopped and held in this position. @ LOWER ( & ) 0 FLOAT ( ,h ) Blade will move freely according to external force. When released from FLOAT position, this lever will not return to HOLD position, so it must be moved back by hand. @ LEFT TILT ( d&f ) @ RIGHT TILT ( a&, ) REMARK To change from ANGLE to TILT, keep the switch at the front of the lever pressed down and return the lever to the HOLD position. Then release the switch and carry out the standard tilt operations.
(Hydraulic angle-tilt dozer only) (Hydraulic angle-tiltdozer) Blade condition Tilt (mm) D31 E-20, D37E-5 D31 P-20A, D37P-5A Right tilt No angling 350 420 I Left tilt Right angle, right tilt 370 306 Right angle, left tilt 315 498 Left angle, right tilt 350 476 Left angle, left tilt 350 345 (Hydraulic tiltdozer) Machine model 1 Tilt Imm) D31 P-20 D31 PLL-20 450 355 Angling control (For hydraulic angle-tiltdozer only) Place the lever in the neutral (HOLD) position. Keep the switch at the front of the lever pressed and operate the lever to the left or right to angle the blade. @ LEFT ANGLE ( 6 ) @ HOLD: Blade is stopped and held in this position.
@ RIGHT ANGLE ( & ) Blade can be angled at 25” on both right and left sides. Left angle Right angle 2-l 1