Komatsu — 16.3 OTHER TROUBLE

16.

TROUBLESHOOTING 16.3.3 ENGINE Problem Main causes Remedy Engine oil pressure warning lamp remains alight when engine speed is raised after completion of warm-up l Engine oil pan oil level is low (sucking in air) l Add oil to specified level, see CHECK BEFORE STARTING l Clogged oil filter cartridge l Replace cartridge, see EVERY 250 HOURS SERVICE (0 Check, repair) l Defective tightening of oil pipe joint, oil leakage from damaged part l Defective warning lamp (0 Replace lamp) Steam is emitted from top pari of radiator (pressure valve) l Cooling water level low, water leakage l Add cooling water, repair, see CHECK BEFORE STARTING l Loose fan belt l Adjust fan belt tension, see EVERY 250 HOURS SERVICE l Dirt or scale accumulated in cooling system l Change cooling water, clean inside of cooling system, see WHEN REQUIRED l Clogged radiator fin or damaged fin l Clean or repair, see EVERY 500 HOURS SERVICE (0 Replace thermostat) l Defective thermostat l Loose radiator filler cap (high altitude operation) l Tighten cap or replace packing Indicator of water temperature gauge is in red range on right side of gauge l Defective water temperature (0 Replace water temperature gauge) gauge Indicator of water temperature gauge is in white range on left side of gauge l Defective water temperature l Defective thermostat l Replace thermostat l Replace water temperature gauge gauge Engine does not start when starting motor is turned l Lack of fuel l Add fuel, see CHECK BEFORE STARTING l Defective fuel injection pump or nozzle l Air in fuel system l Repair place where air is sucked in (* Replace pump or nozzle) l Starting motor cranks engine sluggishly l Heater signal does not glow red I See ELECTRICAL SYSTEM l Defective compression 0 Defective valve clearance (0 Adjust valve clearance) Exhaust gas is white or blue l Too much oil in oil pan l Add oil to specified level, see CHECK BEFORE STARTING l Improper fuel l Change to specified fuel Exhaust gas occasionally turns black l Defective nozzle l Clogged air cleaner element l Clean or replace, see WHEN REQUIRED (0 Replace nozzle) (0 Adjust valve clearance) l Defective compression Combustion noise occasionally makes breathing sound l Defective nozzle (0 Replace nozzle) Abnormal noise generated (combustion or mechanical) l Low grade fuel being used l Change to specified fuel l Overheating l See item “Indicator of water temperature gauge is in red range on right side of gauge”.

(0 Replace muffler) (0 Adjust valve clearance) l Damage inside muffler l Excessive valve clearance 2-61