Komatsu — WORK POSSIBLE USING WHEEL LOADER

. OPERATION OPERATION WORK POSSIBLE USING WHEEL LOADER DIGGING OPERATIONS WARNING 1. When driving the machine forward and lowering the bucket, stop the bucket at height (A) approx. 30 cm (12 in) from the ground, then lower it slowly. completing the shift down, depress the 3 - 140 In a ddition to the following , it is possible to further increase the range of applications by using va rious attac hments. Never carry out digging o r scooping operations with the machine articulated. There is danger that the m achine ma y tip over. When the machine is trav eling or the work equipment is raised, the moment that the E.C.S.S. switch is turned ON , the work e quipment will move.

I f operations are carried o ut with the E.C.S.S. switch left at the ON position, th e moment that the travel da mper is act uated, the work equipment will mov e. NOTICE If th e tires slip, the tire life w ill be reduced, so do not allow the tires to slip durin LOADING PILED SOIL OR BLASTED ROCK When loading piled soil or blasted rock,drive the machine forward as fo llows to load. To preven t cutting o f the tires c aused by the tires slip ping, be careful of the following points during the operation. ks.

Always keep the op erating jobsite flat, and remove any fallen roc When working with stockpiles, operate the machine in 1st or 2nd g ear; when loading blaste d rock op erate the machine in 1st gear . REMARK If th e bucket hits the groun and the tires will slip. Shift down immediate ly in front of the material to be loaded. Wh accelerator pedal at t he same time and thrust the bucket into the m REMARK To reduce fuel consumpti on, depress the accelerator pedal the minimu m possible amount. If it is depres sed fully, the fuel consumption will increase, but there will be no increase in the amount loaded.

When the material is i n a stockpile, keep the cutting edge of the bu cket horizontal; when lo ading blas ted rock, have the bucket tilting slightly down. Be careful not to get b lasted rock under the bucket. This will make the front tires come off t he ground and slip. Try to keep the load unbalanced. in the center of the bucket; if the load is on one side of the bucket, the load will be