. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 165 BEFORE STORA GE g-term storage (more than one month), store as follows. When keeping in lon g-term storage (more than one month), stor Clean and wash a ll parts, then store the machine indoors. If th e machine has to be store d outdoors, s elect level ground and cover the machine with a sheet. cting. ith grease. Completely fill the fuel tank. This prevents moisture from colle Lubricate and cha nge the oil before storage.
Coat the exposed portion of the hydraulic cylinder piston rod w Disconnect the ne gative terminals of the battery and cover it or r emove it from the machine and store it s eparately. Set the lock lever to the LOCK position to prevent the machin e from moving. To prevent rust, fill with Komatsu genuine supercoolant (AF-NA C) to give a density of at l east 3 0% for t he engine coolant. If it is necessary to perf orm the rust-prevention operation while the mach ine is indoors, open the door s and windows to improve ventilation and prevent gas poisoning. During storage, op erate and move the machine for a short dista nce once a month so that a new film of o il will coat moving parts.
At t he same time, also charge the battery. om the hydraulic cylinder rods. When operating th e work equipment, wipe off all the grease fr om the hydraulic cylinder r ods. If the machine is e quipped with an air conditioner, operate the air conditioner for 3 to 5 m inute s once a month to lubricateall parts o check the refriger f the air conditionercompressor. Always run the engine at low idle when doin g this. I n addition, ant level twice a year. NOTICE If the machine has bee n stored without carrying out the monthly rust-p revention operation, consult your Komatsu distributor before using it. When using the mac hine after long-term storage, do as follows b efore using it.
Wipe off the greas e from the hydraulic cylinder rods. e at all lubrication points. Add oil and greas When the machine is stored for a long period, moisture in the air will mix with the oil. Chec k the o il befor e and after starting the engine . If there is water in the oil, change all the o il. mality in the belt. ley, remove it with a wire brush. Check that there i s no rust on the engine pulley and no abnor If there is excessiv e rust on the belt contact surface of the pul ley, remove it with a wire b rush.