. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE until the then 4 - 23 4. Set a container in positio n to catch the coolant, then op valve (3) at the left side 5. After draining the water, water. 6. When the radiator is full, start the engine, and run it at Keep the engine runnin g at low idle for 10 minutes coolant temperature rea ches more than 90°C (194°F 7. Stop the engine, open tighten the drain valve a 8. After draining the water, clean the cooling system wit h cleaning agent For the cleaning method , see the instructions for the cleaning a gent. 9. Replace the corrosion re sistor cartridge (if equipped) , then open For details of the proce corros CARTRIDGE (PAGE 4- 10.
Add the coolant and wa ter mix through the water fille r port until it overflows. To deter mine the mixing rat io for the antifreeze and water , see "WATER AND SUPERCOOLANT MIX RATIO TABLE". 11. To bleed the air from the cooling system, run the engi ne at low id le for 5 minutes, and for a further 5 minut es at high idle. (When doing t his, leave the radiator cap off 12. Drain the coolant from i nside sub tank (4), clean the the sub tank, then add marks. 13. Stop the engine, wait fo r approx. 3 minutes, then add until the coolant level is near the coolant filler port, an the cap. Check the cool ant level and add coolant if ne