. MAINTENANCE SERVICE PROCEDURE LUBRICATE REAR AXLE PIVOT PIN (3 places) 1. Using a grease pump, pump in grease through the grease fittings marked by the arrows. 2. After greasing, wipe off any old grease that was pushed out. CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING engine is stopped, and may cause burns. Wait for the 1.
Lower the bucket horizontally to the ground and stop the 4 - 41 EVERY 100 HOURS SERVICE Maintenance for every 50 hours service sho uld be ca rried out at the The parts and oil are at high temperature i mmediately temperature to go down before startin g the w When removing the oil filler cap, turn i t slowly to release the intern t for 5 minutes, then check sight gau ge (G). ld be between the H and L NOTICE If the oil has been a dded to above H level , stop th e engine a nd wait fo hydraulic oil to coo l down, then drain the excess oil from the drain plu the oil is above H le vel, it will damage the hydraul ic circuit o r cause th to spurt out.
below the L mark, a dd oil t hrough oi l filler (F)