Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE installed to the bottom of the bottom of cup (3) of the fuel Cap (A) acts to prevent the entry of dirt or dust into the filter cartridge. 4 - 51 5. Using a filter wrench, turn filte on remove it. 6. 7. Take water separator cup (3) cartridge and turn it to the left again. If it is damaged, replac Install cup (3) to the bottom of When doing this, always repla Tightening torque for cup: 10 When replacing the seal ring, before installing it. Check that drain plug (4) at t 8. pre-filter is tightened securely. Tightening torque: 0.2 - 0.45 N 9. Clean the filter holder.

NOTICE When filling the filter cartridge with fue cap Cap (A) fitted. (A) acts to prevent the entry of dir 10. Fill the filter cartridge with clea 11. (B) in the new filter cartridge. Coat the packing surface of th 12. Remove filter cartridge cap (A ) and install to the filter holder. 13. When installing, tighten until th e packing surface contacts the seal surface of the filter h older, then tighten it 3/4 of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lead t o leakage of fuel.

If the filter cartridge is too loose, fue l will also leak from the packing, so always tighten the co When tightening with a filter wrench, be extremely careful not to dent or damage the 14. Connect connector (1). When replacing the fuel main 15. CARTRIDGE (PAGE 4-53)" fo Note: Do not put any fuel in th 16. Start the engine, check that th ere is no leakage of fuel from the filter seal surface or wa ter separator mounting surface, then run for approx. 1 0 minutes at low idling.