Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHECK OF ENGINE AIR INTAKE PIPING CLAMPS FOR LOOSENESS CHECK ALTERNATOR DRIVING BELT TENSION AND REPLACEMENT REMARK 4 - 57 Please ask yo ur Komatsu distributor to check the tightening o f the clamps between the air cleaner - turbocharger - aftercooler - Since inspecti on and replacemen t of th e fan belt r equires special tools, contact your Ko matsu distributor. The machine i s equipped with an auto t ensioner, so there is n o need to adjust the tensio If the alternato r drive belt is in t he f ollowi ng conditio n, the belt m ust be replaced. belt.

When horiz ontal scratch (1) crosses vertical scr atch (2) When there are tears (3) in par t of th In case (4) wh need to replac REPLACE CORROSION RESISTOR CARTRI DGE o points. 1. Close a va 2. Using a filt 3. Apply engi install it to 4. Bring the p the filter h 5. Open a va lve (1) of the corrosion re sistor at tw er wrench, turn cartridge (2) to the l eft to remov e it. ne oil to the sealing surfa ce of a new cartridge, t hen the filter holder. acking surface into older, then tighten it conta furthe ct with the r approx. seal surface of 2/3 turn. o points. lve (1) of the corrosion re sistor at tw