Komatsu — WORK POSSIBLE USING COMPACT HYDRAULIC EXCAVATOR

. OPERATION MACHINE OPERATIONS AND CONTROLS WORK POSSIBLE USING COMPACT HYDRAULIC EXCAVATOR 3 - 78 In addition to th e following, it is p ossible to further increase the range of applications by u sing various attachments Backhoe Wor k for excavating places lower than the machine. ipment is in condition shown in diagram on right and link r line of arm cylinder and arm foot pin is at 90°, the g force of each cylinder is the maximum. um use of this angle during digging operations to erating efficiency.

This is suitable for excavating p laces lower than When work equ ipment is in condition shown in d Bucket cylinder When the cente r line of arm cylinder and arm foo push-out diggin g force of each cylinder is the ma Make the optim um use of this a increase the op erating efficienc The range for e xcavating with t he arm is from a 45° angle away hine. from the machi ne to a 30° angle toward the mac There may be s ome difference s depending on t he digging depth, not try to keep within the above range rather tha n operating to the end of the cylin der stroke.

Ditching Wor k an be performed efficiently by attaching a bucket Ditching work c which matches the digging operation and then ne of the ditch to be excavated. parallel to the li ne of the ditch to To excavate a remove the cen Loading Work the swing angle is small, work efficiency can be In places where enhanced by lo cating the dump truck in a place e asily visible to the operator. Loading dump t rucks is easier a nd the loading c apacity is greater if the hydraulic excavator loads from the rear of the dump truck the side. rather than from