Komatsu — DISCHARGED BATTERY

. OPERATION TROUBLES AND ACTIONS Battery Removal and Installation NOTICE After securing the battery, check that it does not move. If it moves, tighten it again securely. 3 - 107 Before removing the battery, r emove the ground cable (normally connected to the nega tive (-) terminal). If any tool touches between th e positive terminal and the chassis, there is a hazard of s parks being generated. When installing the battery, co nnect the ground cable last. Install the battery securely to t he determined place. When doing this, be careful not to let the clamps conta ct the terminals. x the battery securely with battery g bolt (2): gf·m, 3.6 to 4.3 lbft) p of the battery covers the battery ack.

ce it immediately. terminals, wash with water of a (104°F), then dry completely and When replacing the battery, fi clamp (1). Tightening torque for mountin 4.90 to 5.88 N·m (0.5 to 0.6 k Make sure that the cover on to completely. Do not let it roll b If the cover is damaged, repla If there is salt on the battery temperature of approx. 40°C remove with a wire brush. Battery Charges e battery is not handled correctly, may explode. Always follow the ATTERY (PAGE 3-106)" and the g the charger, and do as follows. generated when the battery is ery from the chassis, take it to a move the battery caps before ecurely. If any battery cap is ely. r to match the voltage of the battery to be charged.

If the correct voltage is not erheat and cause an explosion. ger clip of the charger to the positive (+) terminal of the battery, then connect the When charging the battery, if th there is a hazard that the battery instructions of "DISCHARGED B instruction manual accompanyin Flammable hydrogen gas is charged, so remove the batt well-ventilated place, and re charging it. Tighten the battery caps s damaged, replace it immediat Set the voltage of the charge selected, the charger may ov Connect the positive (+) char ttery, then conne negative (-) charger clip of the charger to the negative (-) terminal of the battery. Be sure to fix the clips securely.

Set the charging current to 1/1 0 of the value of the rated battery capacity; when carrying out rapid chargin g, set it to less than the rated batter y capacity. If the charger current is too hig h, the electrolyte will leak or dry up, and this may cause the battery to catch fir e and explode. If the battery electrolyte is fro zen, do not charge the battery or start the engine with a different power source. ll ignite the battery electrolyte and cause the battery to explode. There is a hazard that this wi ll ignite the battery electrolyte and cause the battery to exp Do not use or charge the batte ry if the battery electrolyte level is below the LOWER LEVE L line.

This may c ause an explosion. Always check th e battery electrolyte level periodically and add distilled wate r to bring the electrolyte level to the UPPER LEVEL lin e.