Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE 4 - 18 5. D kgf/cm SI)) from t he inside of the oute r element along i ts folds. Then irect the co mpressed air from t he outside along the fold s, and gain from t he inside. the element whic 1) Replace repeate dly or used through 2) Replace element when th soon after installi t has not been clea piston elemen 6.

If small hole re found on the element when is checked by shining a light th rough it after cleaning, r eplace e element NOTIC E When cleaning th e element, do not hit it or beat it against somethi Do no t use an ele ment whose folds or g asket or seal are d amaged Wrap unused ele ment and store them in a dry place. 7. R emove th e cloth or adhesiv e tape used to cover the air body. new element. c onnector in side the air cleaner 8. In stall clean ed element (4) or a 9. S et dust cu p (3) with the arow p ointing up, then set it to the air cl eaner bod y and secure it with clip (2). 10. P ress the b utton of dust indicat or (1) to return th e red pi ston to it s original p osition.