. MAINTENANCE MAINTENANCE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING Use a permanent type of antifreeze. If, for some reason, it is impossible to use permanent type antifreeze, use an antifreeze containing ethylene glycol. The proportion of the mixture differs according to the ambient temperature, but to obtain the corrosion resistance effect, a minimum of 30% by volume is necessary. In areas where the water is hard, always add Komatsu genuine corrosion resistor agent KI. One packet of corrosion resistor agent contains 100 g (0.22 lb). The standard density of the mixture should be 7 g/liter (0.065 oz/US gal).
4 - 22 Immediatel y after th e engine is stopped, th e coolant is at a high temperature and the radiato r is under high intern al pressure. If th e cap is removed to drain t he coolant in t his condition, th ere i s a hazard of b urns. Wait for the temperatur e to go down , then turn the ca p slowly t o release the pressure before removing it. Cleaning is carried o ut with t he engine runn ing. When standing up or l eaving th e operator's seat, set the s afety l ock lever to the LOCK position. For details of starting the eng ine, see"BEFO RE STARTING E NGINE (PAGE 3-40)" and "STARTING ENGINE ( PAGE 3-54)" in the OPERATIO N section .
The engine is operat ed when washing, so it is dangerous if t he machine move s when you are standing behind it. Never stand behind the machine when the engine is run ning. Stop t he ma chine on level gr ound when c leaning or changing the coolant. Clean the in side of th e coolin g system, ch ange the coolant a nd replace t he corrosion r esistor a ccording t o the table below Kind of coolant Cleaning inside of cooling system and changing coolant Adding corrosion resistor agent KI Permanent type antifreeze (All season type) Every year (autumn) or every 2000 hours whichever comes first Every 1000 hours and when cleaning the inside of the cooling system and when changing coolant.
Non-permanent type antifreeze containing ethylene glycol (winter, one season type) Every 6 months (spring and autumn) (Drain antifreeze in spring, add antifreeze in autumn) When not using antifreeze Every 6 months or every 1000 hours whichever comes first