. MAINTENANCE MAINTENANCE PROCEDURE WARNING the NOTICE When adding distilled water in cold weather, add it before starting operations in the morning to prevent the electrolyte from freezing. When Checking Electrolyte Level from Side of Battery to 4 - 25 CHECK LEVEL OF BATTERY ELECTROL Carry out this check before operating the machi Do not use the batte ry if the battery electrolyte lev el is below the LO WER LEVEL line. This will accele rate deterioration of inside of the battery and reduce the service life of the battery. In add ition, it m ay also cause an explo sion. near the battery.
The battery generat es flammable gas and there is danger of explosio n, so do not bring fire or sparks Battery electrolyte i s dangerous. If it gets in your e yes or on your ski n, wash i t of f with a large amoun t of water and cons doctor. ed water to the battery, do not allow the battery electrolyte to go above the UPPER LEVEL line. If oo high, it may leak and cause damage to the paint surface or corrode other parts. When adding distill electrolyte level is t oo high, it may leak and cause damage to the pai nt surfac e or corrode other parts Inspect the battery e lectrolyte level at least onc e a month and fo llow the basic safety proced ures given below.
If it is possible to ch eck the electrolyte level fro m the side of the battery, 1 2 . Open the cover at the right side of the mach . Use a wet cloth lines and chec UPPER LEVEL If the battery is cause a fire or e to clean the area around th e electrolyte lev k that the electrolyte leve (U.L.) and LOWER LEVEL . If the electrolyte level is below the midway point between th U.L. and L.L. lin the U.L. line. es, remove cap (1) and add distilled water illed water, tighten cap (1) securely. . After adding dist illed water, tighten cap (1) s REMARK If distilled water is a dded to above the U.L. line, use a syringe If d lower the level to th e U.L. line.
Neutralize the r emoved fluid wi baking soda (sodium bicarbonate), then flush it away with a larg amount of water or maker. consult your Komatsu distributor or batte