. MAINTENANCE MAINTENANCE PROCEDURE REPLACE BUCKET TEETH WARNING REMARK lock pins and rubber pin locks with the following defects are used, the teeth may come off the bucket. Replace 4 - 38 It is dan gerous if the wo rk equipment moves by mistake when th e teeth are bei ng replaced. Set the work equipment in a stable condition, s top the engine, t hen set the saf ety lock levers se curely to the LOCK po sition (L). The pin is knocked out b y force, so there is dan ger of the pin flyi ng out. Check that nobody is in the surrounding area. uring the replacement There is danger of br oken pieces flying d operati on, so wear protective glasses, gloves, and other protective ent.
tective equipm For machines equipped with a cab, there is only a safety lo ck lever on Replace the bucket teet h before the adapter starts to wear. et the 1. . To m ake it possible to knock out the pin of tooth (1), s botto m surface of th e bucket on a block , check that th e work equipment is in a sta ble condition, then se t the safety loc k lever to the LOCK positio n. m face of the bucket is horizontal. Set s o that thebotto m face of the bucket . Use a hammer and drift to knock out lock pin (2). (If the drift is set a gainst rubber p in lock (3) when it is h it, the rubber p in lock may break. Set it ag ainst the back of the pin.) .
After removing lock pin (2) and rubber pin lock (3), check them. If lock pi ns and rubber them wit h new ones. The lo ck pin is too sh owing defects are used, th