. MAINTENANCE MAINTENANCE PROCEDURE BLEEDING AIR FROM HYDRAULIC SYSTEM filling the pump case with hydraulic oil, there is danger that the pump may be prematurely 4 - 43 NOTICE If the damaged. Be sure to bleed 1. Bleeding air from pis 1) Remove bolts (1 (2). 2) Remove the oil f 1) Remove bolts (1 ) (M10 x 3), then remove triang 2) Remove the oil f iller cap from the hydraulic oil ta 3) Loosen air bleed plug (3) and check that oil ooze the bleeder plug 4) After completion air bleed plug. 5) Tighten the oil fil ler cap of the hydraylic 6) Install the cover. 2. Start the engine. For details, see "STARTING ENGI NE (PAGE Run the engine at lo w idling for 10 minutes, then do as follows 3.
Bleeding air from cyl NOTICE If the engine is run at high s peed immediately after startup or a c ylinder is pushed up to its strok e end, air taken inside the cylinder may cause damage to the p 1) Run the engine a t low idling, and extend and retra ct each cylinder 4 to 5 time s, taking care so that a c ylinder may not be brou ght up to its stroke end. (Stop th e cylinder approx. 100 mm (3.9 in) short of its strok e end) 2) Next, operate ea ch cylinder 3 to 4 times to the e nd of its stroke. tely remove the air. 3) Finally, operate each cylinder 4 to 5 times to the end of its stroke to comple