Komatsu — LUBRICATING

. MAINTENANCE MAINTENANCE PROCEDURE Lubricating Work Equipment and maintenance 4 - 47 NOTICE When breaking in a ne w machine, carry out lubrication e very 10 hours for the first 100 hours of oper I f any abnormal soun nterval. d comes from the greasing point, carry out greasing regardless of the insp ing work in water, always lubricate the pins that were under water. i A fter carrying out digg ing work in water, always l ubricat e the pin s that Prepare a grease g 1. Set the machine t o the greasing posture shown on the diagram, lower the the engine. Using a grease p the hen 2. fittings shown by a 3. After greasing, wip e off any old grease tha t was pushed out.

(1) Bucket - Link conn ecting pins (1 place) (2) Arm - Bucket conn ection pin (1 place) pin (1 place) end (1 place) place) (3) Arm - Link coupling (4) Bucket cylinder rod (5) Link coupling pin (1 (6) (7) Blade cylinder foot Blade cylinder rod (8) Blade foot pin (2 pl (9) Boom cylinder foot (10 ) Boom swing brac ket pin (2 places) (11 ) Boom swing cylin der rod end pin (1 place) (12 ) Boom foot pin (2 places)