Komatsu — REPLACE HYDRAULIC OIL FILTER ELEMENT

. MAINTENANCE MAINTENANCE PROCEDURE EVERY 1000 HOURS MAINTENANCE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING NOTICE If the machine is equipped with a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-16)" when carrying out maintenance. the internal 4 - 55 Carry out the main tenance for EVERY 500 HOU T he parts and oil ar e at high temperature after the eng ine is stopped, and may cause burns. Wait for the temperature to go down b efore starting the work. e oil filler cap, turn it slowly to release the internal pressure, then remove it.

W hen removing th e oil filler cap, turn it slowly to rel ease the internal pressure, 1. Open dust cov er (1) fully until it is secured in (For details of t he method of opening and closi the lock, see S Cover (PAGE ection "In Case of Engine Rea 3-28)") 2. Loosen bolts (2 ), then remove plate (3) to the 3. Remove the c pressure. ap from oil filler (F), and rele 4. Remove bolts ( the cover may 4), then remove cover (5). W fly off under the force of spring 5. cover pushed d After removing own when removing the bolts. spring (6) and valve (7), take 6. Clean the remp ved parts in diesel oil. 7. Install the new element where old element (8 ) was installed.

Inspect the O-r ing set between the hydraulic t ank and cover (5). If there are any scratche s, replace the O-ring. 8. Set valve (7) a nd spring (6) on top of the elem ent. d, and tighten cover mounting bolts (4) to install cover (5). ully as shown in cap, then install surized, the pump ent. 9. Set cover (5) in position, hold it down by han d, and tighten cover mounting bolts (4) to in 10. Extend the boo m, arm, and bucket cylinder f the diagram on the right, remove the oil filler the cap and pressurize the inside of the tank. NOTICE the diagram on the right, remove the oil filler the cap and pr essurize the inside of the tank. Be s ure to pressurize the hydraulic tank.

If it is not pres will suck in air, and th is will adversely affect the equipm 11. Close cover (1) at right side of the machine. 11. Close cover (1)