Komatsu — CONTROL PATTERN CHANGE PROCEDURE

. ATTACHMENTS AND OPTIONS CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) CHANGING MACHINE CONTROL PATTERN (IF PATTERN CHANGE VALVE EQUIPPED) WARNING 6 - 18 When changing th e operating pattern of the machine, s et the machine in the parking posture, st op the engine, check th at the safety lock lever is at the LOCK position, the n change t he operating p attern.

T o prevent persona l injury caused by mistake n operation , test operate the machine and check tha t the display on the ope rating pattern card is the same as the movement of the machi If it is not the same , replace the operating pa ttern card i mmediately w ith the card that matches t When checking the movement of the machin e, check ca refull y that th e surrounding area is safe, CONTROL PATTERN CHANGE PROCEDU RE 1. Open the hatch pattern selector 2. Follow the st patterns. 1) Loosen hex 2) The operati or down. Position (A) Position (B) 1. Open the hatch at the bottom achine. Th pattern selector valve is inside. Follow the st patterns.

1) Loosen hex ng pattern changes when lever (2) is moved u : ISO pattern : Backhoe position 3) After switch ing, tighten hexagon so cket hea d bolt (1). hat matches the selected operating pattern. 3. Change to an o perating pattern card (i nsert it in the holder) t hat matches the selecte d operating pattern. 4. Start the engine , set the safety l ock lev er to the F REE positio n, operate the work equ ipment levers slowl y, and check that the operating pattern has ch anged.