Komatsu — WORK EQUIPMENT • SWING PPC VALVE

STRUCTURE, FUNCTION, & MAINTENANCE STANDARD WORK EQUIPMENT • SWING PPC VALVE OPERATION 1) At neutral Ports A and B of the control valve and ports P1 and P2 of the PPC valve are connected to drain chamber D through fine control hole f in spool (1). (Fig. 1) 2) During fine control (neutral fine control) When piston (4) starts to be pushed by disc (5), retainer (9) is pushed; spool (1) is also pushed by metering spring (2), and moves down. When this happens, fine control hole f is shut off from drain chamber D , and at almost the same time, it is connected to pump pressure chamber PP , so pilot pressure oil from the main pump passes through fine control hole f and goes from port P1 to port A .

When the pressure at port P1 becomes higher, spool (1) is pushed back and fine control hole f is shut off from pump pressure chamber PP . At almost the same time, it is connected to drain chamber D to release the pressure at port P1 . When this happens, spool (1) moves up or down so that the force of metering spring (2) is balanced with the pressure at port P1 . The relationship in the position of spool (1) and body (10) (fine control hole f is at a point midway between drain hole D and pump pressure chamber PP ) does not change until retainer (9) contacts spool (1).

Therefore, metering spring (2) is compressed pro- portionally to the amount of movement of the con- trol lever, so the pressure at port P1 also rises in proportion to the travel of the control lever. In this way, the control valve spool moves to a position where the pressure in chamber A (the same as the pressure at port P1 ) and the force of the control valve spool return spring are balanced. (Fig. 2) 10-118 PC210/240-7K