Komatsu — machine control system diagram

STRUCTURE, FUNCTION, & MAINTENANCE STANDARD ELECTRONIC CONTROL SYSTEM 12 1) LS control function The change point (LS set differential pressure) of the pump discharge in the LS valve is changed by chang- ing the output pressure from the LS-EPC valve to the LS valve according to the operating condition of the actuator. By this operation, the start-up time of the pump dis- charge is optimized and the composite operation and fine control performance is improved. 2) Cut-off function When the cut-off function is turned on, the PC-EPC current is increased to near the maximum value. By this operation, the flow rate in the relief state is lowered to reduce fuel consumption.

Operating condition for turning on cut-off function 08922 Condition The average value of the front and rear pressure sensors is above 27.9 MPa {285 kg/cmІ} and the one-touch power maximizing function is not turned on The cut-off function does not work, however, while the machine is travelling in mode A or the arm crane operation width swing lock switch is turned on. 1. 2-stage relief function The relief pressure in the normal work is 34.8 MPa {355 kg/cmІ}. If the 2-stage relief function is turned on, however, the relief pressure rises to about 37.2 MPa {380 kg/cmІ}. By this operation, the hydraulic force is increased fur- ther.

Operating condition for turning on 2-stage relief func- tion 10-178 PC210/240-7K Condition Relief pressure • During travel • When swing lock switch is turned on • When boom is lowered • When one-touch power maximizing function is turned on • When L mode is operated 34.8 MPa {355 kg/cm²} ⇓ 37.2 MPa {380 kg/cm²}