STRUCTURE, FUNCTION, & MAINTENANCE STANDARD ELECTRONIC CONTROL SYSTEM 12 1) One-touch power maximizing function When the operator needs more digging force to dig up a large rock, etc., if the left knob switch is pressed, the hydraulic force is increased about 7% to increase the digging force. If the left knob switch is turned on in working mode "A" or "E", each function is set automatically as shown below. Software cut-off function 10-180 PC210/240-7K Working mode Engine/Pump con- trol 2-stage relief function Operation time A, E Matching at rated output point 34.8 MPa {355 kg/cm²} ⇓ 37.2 MPa {380 kg/cm²} Automatically reset at 8.5 sec Cancel