Komatsu — machine control system diagram

STRUCTURE, FUNCTION, & MAINTENANCE STANDARD ELECTRONIC CONTROL SYSTEM 2) Quick hydraulic oil warm-up function when swing lock switch is turned on If swing lock switch (4) is turned on, the pump-cut function is cancelled and the relief pressure rises from 34.8 MPa {355 kg/cmІ} to 37.2 MPa {380 kg/cmІ}. If the work equipment is relieved under this condition, the hydraulic oil temperature rises quickly and the warm-up time can be shortened. 12 1) Swing lock and swing holding brake functions The swing lock function (manual) is used to lock machine from swinging at any position. The swing holding brake function (automatic) is used to prevent hydraulic drift after the machine stops swinging.

Swing lock switch and swing lock/holding brake Operation of swing holding brake release switch If the controller, etc. has a problem, the swing holding brake does not work normally, and the machine can- not swing, the swing lock can be reset with the swing holding brake release switch. Even if the swing holding brake release switch is turned on, if the swing lock switch is turned on, the swing brake is not released. If the swing lock is reset, swinging is stopped by only the hydraulic brake of the safety valve. Accordingly, if swinging is stopped on a slope, the upper structure may drift hydraulically.

10-186 PC210/240-7K Lock switch Lock lamp Function Operation OFF OFF Swing holding brake If swing lever is set in neutral, swing brake operates in about 5 sec. If swing lever is operated, brake is released and machine can swing freely. ON ON Swing lock Swing lock operates and machine is locked from swinging. Even if swing lever is operated, swing lock is not reset and machine does not swing. Swing holding brake release switch ON (When control has trou- ble) OFF (When controller is normal) Swing lock switch ON OFF ON OFF Swing brake Swing lock is turned on. Swing lock is canceled. Swing lock is turned on. Swing holding brake is turned on.