. OPERATION EXPLANATION OF COMPONENTS OFF SWITCH preferred air flow, to prevent dust from entering the cab. PRECAUTIONS WHEN USING AIR CONDITIONER 3 - 56 AIR CONDITIONER SWI This switch (5) is used to switch the air conditioner ON/OF REMARK For machines equippe d with a heater only , switch (5) is not available. (Option Switch (6) is used to st op operation of the REMARK When fresh air is tak en into the cab, air pressure in the cab press increases, which preve nts the dust from entering .
When neither heating nor cooling is needed, bring in clean fres h air, wit WHEN CARRYING OUT COOLING, VENTILATE THE CAB FROM TIME TO TIME If you smoke when th e cooler is on, the s moke m ay start t o hurt your eyes, s o turn th e lev er to FR ESH to r emove the smoke while con tinuing the cooling. g periods, carry out ventilation once every hour. When the air conditi oner is used for lon g period s, carry o ut ventilation o nce every h BE CAREFUL NOT TO C OOL TOO MUCH h, it is recommended that the cab should feel pleasantly cool when you enter it from the For reasons of healt h, it is recommended outside (5 to 6°C (9 .0 to 10.8°F) lower than the outside temperature).
Pay attention to the temperature when carrying out cooling. should feel pleasantly coo SET SO THAT COLD AIR DOES NOT DIRECTLY BLOW ONTO THE GLASS SURFACE If the vents (left and r ight) in the middle o f the da shboard are turned so t hat c old air p lays directly on the ca b door glass, moisture may condense on the outside of the cab door glass and reduce the visibility. (This occurs mperatures.) the vent fully to the rear and raise the air conditioner temperature setting slightly. outside glass visibilit occurs particularly in high te If this happens, turn the vent fully to the rear an d raise th e air conditioner te mperature s etting sl