Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING engine is stopped and may cause serious burns. Wait for the oil the 3 - 64 Parts and oil are at high temperature immediate ly after the temperature t o go down before performing this o peration. 1. Open th e engine side co ver on the left side of the chassis 2. Remove dipstick (G), an d wipe the oil o ff with a cloth. 3. Fully ins ert dipstick (G) i nto filler pipe (F ), then remove it. 4. The oil l evel should be STOPPED side between the H ENGINE If the oil of dipstick (G level is below th e L mark, add oil through oil f iller 5. If the oil is above the H mark, remove drain plug (1), drain val again. 6.

If the oil ve (2) to drain th e excess oil, t hen check the oil l close the engine side co REMARK When ch ecking the oil lev el after the en gine has been operated , wait for at least 15 min utes after stopping the engine be fore checking. gle make it horizontal before checking. the dipstick form the holder to release the air inside the crankcase. If the mac hine is at an an gle make it hor izontal before checking When ad ding oil, remove the dipstick for m the holder t o release the air inside the crank The dipst ick is marked wit h the levels for "ENGINE STOPPED" o n one side and "ENGIN E IDLING" on the other side.

It is also · Check o · Read th possible to check the oil level with the engine idling, but be sure to remember the following points. il when the engine coolant temperature gauge is within the green range. e dipstick on its reverse side marked with "ENGINE IDLING". possible to chec k the oil level w ith the engine idling, bu t be sure to remember t il when the engi ne coolant tem perature gaug e is within e dipstick on its reverse side m arked with "ENGINE