. OPERATION OPERATION OPERATION OPERATION (F)Front of the machine 4) Remove hose (1), loosen drain valve (2) and drain the excess oil, then check the oil level. 5) If the oil level is correct, tighten the oil filler cap securely. (A): Remove REMARK When checking the oil level, if the machine is at an angle, move it to a horizontal position before carrying out the check. When checking the oil level before starting operations, check with the engine stopped and use the dipstick COLD STOP side. It is also possible to check the oil level after the engine has been run and the power train oil temperature is high, but in this case, run the engine at idling and use the dipstick HOT IDLING side.
3 - 66 4. I f the oil l evel i s above the H line, drain oil as follows 1) Remove 2 bolts (4) at t he fron t of the machine. 2) Hold down the c over (3 ) and gradually remove 2 bolts (5) at the rear of the machi 3) Cove r (3) i s fitte d with a hinge pin at th e front, so gradually lower cove r (3).