Komatsu — CHECK BEFORE STARTING ENGINE, ADJUST

. OPERATION OPERATION USING SEAT BELT Always install a seat belt on machines equipped with ROPS. WARNING brake pedal fully, and adjust the tether belt (1). Tense tongue (4) connected to wind-in (3) until it clicks. The belt is pulled (2) until it is fitted to your under this condition and cannot belt to your abdomen without then repeat the above procedure from the start. 3 - 72 Before fastening the seat belt, insp ect the securing brackets and belt for Replace any worn or damaged sea Even no problem can be seen with the belt, always replace the seatbelt once every three years. The date of manufacture is given on the rear side of the belt. ore operating the machine. rating the machine.

thout twisting. Adjust and fasten the seat belt bef Always use the seat belt when ope Fi t the seat belt across your lap wi FASTEN THE BELT AND REMOVE IT 1. 2. 3. 4. 1. Sit on the seat, depress the seat so that your back is pres 2. After adjusting the seat positi the tether belt and install it wh seat. Sit on the seat and hold to 3. mechanism (2) and pull out th cover your abdomen sufficien 4. Insert tongue (4) in buckle (3 back into wind-in mechanis abdomen. The belt is locked be extended anymore. Fit th twisting it. REMARK If th e belt is locked before the ton it 5. Pull the belt to check that it is 6.

When removing the belt, pres The belt will automatically ret Check that the bolts of the clamp securing the belt to the chassis are not loose. Tighten t Tightening torque: 24.5 ± 4.9 Nm If th e seat belt is scratched or fray ed, if any fittings are broken or deformed from long serv ice, replace the seat belt immediately.