Komatsu — SHIFTING GEAR

. OPERATION OPERATION OPERATION OPERATION When the joystick is in the N position, if UP switch (a) or DOWN switch (b) is pressed, the shift mode selection can be carried out. The selected shift mode is displayed on auto shift mode display lamp of the monitor panel. In [F1 - R1] shift mode (initial setting is completed) Lamps (c) and (d) are OFF. In [F1 - R2] shift mode (initial setting is completed) Lamp (c) is ON and lamp (d) is OFF. In [F2 - R2] shift mode (initial setting is completed) Lamp (d) is ON and lamp (c) is OFF. 3 - 87 Shift operation when [F1-R2] shift mode is set When the joystick is at the N position and the UP switch i mode and lamp (c) lights up.

Following this, if the joystick range is set to F1. If the lever is operated to the rear (t switched R1 → R2. s pressed once, the transmission is set to the [F1-R2] is operated forward (to set to FORWARD), the speed o set to REVERSE), the speed range is automatically Shift operation when [F2-R2] shift mode is set When the joystick is at the N position and the UP switch i mode and lamp (d) lights up. Following this, if the joystick range is set to F1 → F2. If the lever is operated to the rear switched R1 → R2.

s pressed twice, the transmission is set to the [F2-R2] is operated forward (to set to FORWARD), the speed (to set to REVERSE), the speed range is automatically REMARK Even when the transmission is set to [F1-R1] mode, [F1-R 2] mode, or [F2-R2] mode, if the UP switch or DOWN switch is operated, this will be given priority and manual op eration can be carried out. For example: After the [F1-R2] mode has been set, if the joystick is opera ted forward (to set to FORWARD), the speed range is set to F1. However, if the lever is kept operated forward an d UP switch (a) is pressed once, the speed range will shift to F2; if the UP switch is pressed twice, the speed range will shift to F3.

When the transmission is in F3 and DOWN switch (b) is pressed once, the speed rang e will shift to F2; if the DOWN switch is pressed twice, the speed range will shift to F1. On the other hand, if the joystick is operated to the rear (to set to REVERSE), the speed range is automatically switched R1 → R2. However, if the lever is kept operated t o the rear and UP switch (a) is pressed once, ressed once, the speed range will shift to R1. the speed range will shift to R3; if the DOWN switch (b) is p However, the setting stays in the [F1-R2] mode.

If the steeri ng, directional, and gearshift lever is returned to N and then operated forward (to set to FORWARD), the speed ran ge is set to F1; if the lever is operated to the rear (to set to REVERSE), the speed range is automatically switched R1 → R2.